Go back to the network settings to see what IP address you received. You will be kicked out of that menu and in a few seconds your NVR will contact the router to get an available IP address. We will be focusing on getting an IP address for the NVR. Go to network and the following page will display:ĭepending on the type of NVR you have, some will have additional settings, but overall the steps are the same. At this point you will notice that there are 3 parts of this window menu: The top is operation, mid is info, and bottom is setting. Most of our NVRs will have a new interface, the “blue interface”, and the menus will be spread out a bit different than the previous version. Of course, you need to be connected to a monitor to see these settings. After the unit turns On you will then need to go to the network settings of the NVR. The easiest way to figure what to do at this point is to connect the recorder to the power supply that comes with the unit and then connect an Ethernet cable from your router to the Ethernet port of the NVR. This way, it will prevent any IP conflict when configuring the IP camera and the NVR security recorder. By default, all of our recorders will be set with a static 192.168.1.108 and the majority of the IP cameras will be DHCP. One thing I will recommend to you is to investigate how your network is laid out and have some knowledge of how many computers are connected to your network. In this article, I will describe what I think are the best settings you should have in your NVR and IP cameras. For years, many customers have asked me what is the best way to to connect an IP camera to an NVR (Network Video Recorder).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |